If you haven't installed your network card and adapter driver, do so now.
Descriptions to perform this task is beyond the scope of this document.
Go to 'Control Panel' -->
'Network' -->
Protocols
Add the TCP/IP Protocol and related Components from the 'Add Software' menu if you don't have TCP/IP service installed
already.
Under 'Network Software and Adapter Cards'
section, highlight the 'TCP/IP Protocol' in
the 'Installed Network Software' selection
box.
In 'TCP/IP Configuration', select the
appropriate adapter, e.g. [1]Intel EtherExpress Pro/100+.
Then set the IP Address to 192.168.0.x (1 < x < 255), then set the Subnet
Mask to 255.255.255.0 and Default Gateway to 192.168.0.1.
Do not enable any of the following options (unless you know what you are doing):
'Automatic DHCP Configuration' : Unless you
have a DHCP server running on your network.
Put anything in the 'WINS Server' input
areas : Unless you have setup one or more WINS servers.
Enable IP Forwardings : Unless you are
routing on your NT machine and really -REALLY- know EXACTLY what you're doing.
Click 'DNS', fill in the appropriate
information that your Linux host uses (usually found in /etc/resolv.conf) and
then click 'OK' when you're done.
Click 'Advanced', be sure to DISABLE
'DNS for Windows Name Resolution' and
'Enable LMHOSTS lookup' unless you known
what these options do. If you want to use a LMHOSTS file, it is stored in
C:\winnt\system32\drivers\etc.
Click 'OK' on all dialog boxes and restart
the system.
As an initial test, ping the Linux MASQ server to test the
network connection: 'File/Run', type:
ping 192.168.0.1(This is only an INTERNAL LAN connection
test, you you might not be able to ping the outside world
yet.) If you don't see any "replies" to your PINGs, please verify your network
configuration.
Configuring the other internal to-be MASQed machines
